Full 25-point door and opener safety check with every visit - springs, cables, rollers, tracks, and your LiftMaster or Chamberlain opener included
You get a price before we start. It does not change when the truck arrives.
Clopay Weather Seal Replacement: The Dripping Springs Owner’s Guide
We stock and install Clopay-compatible weather seal replacement in Dripping Springs, and most swaps run $110-$220 installed, finished the same visit. You’ll usually spot the failure the same way every homeowner does: daylight sneaking under the door, leaves and dirt piling up in the corner of the garage, or a mouse that found the gap before you did. The seal at the bottom of a Clopay door takes abuse from the Texas sun and the limestone dust that blows through this part of the Hill Country, and once it goes, it goes fast. We carry the common Clopay profiles on the truck, so Otto or one of his crew can match your seal to your door and have it replaced before you finish your coffee.

Which Clopay Models This Applies To
Clopay runs three residential lines you’ll find all over Dripping Springs: the Classic series, the Gallery series, and the premium Coachman and Reserve wood-look doors. The bottom seal isn’t universal across those. Clopay uses a few different retainer profiles depending on the door’s age and model, and the wrong seal will either fall out in a week or bind the door so the opener strains against it. The most common on Clopay doors made in the last 15 years is a T-style retainer with a round bulb, but older Classic doors sometimes run a U-channel that takes a flat flap seal instead. The surest way to know is to look for the Clopay label on the inside of the door panel near the bottom bracket. If that label’s gone, we measure the retainer channel width with a caliper right at the visit. We’ll show you the old seal next to the new one before it goes in.
One thing worth knowing on the OEM-versus-aftermarket question: Clopay ships factory seals through its dealer network, and they’re fine parts. But for everyday weather sealing in this climate, a quality aftermarket equivalent made from EPDM rubber holds up at least as well against UV and heat, and it costs the homeowner less. We’re an independent shop, not affiliated with Clopay, so we’ll tell you straight which one makes sense for your door and your budget.
Signs Your Clopay Weather Seal Replacement Is Failing
- Daylight under the door - If you can see a sliver of light along the floor when the door’s closed, the bulb has compressed beyond recovery or torn. That gap is also an invitation for scorpions and field mice, which we see plenty of out here near the Pedernales.
- Dirt, leaves, and cedar pollen inside the garage - Dripping Springs wind pushes debris under any door with a weak bottom seal. If you’re sweeping more than usual, the seal isn’t sealing.
- Water seeping in after a Hill Country downpour - Those fast storms we get in the spring and fall dump water against the door in minutes. A worn Clopay seal lets that water run right across the garage floor and under your stored boxes.
- You can see cracks, splits, or flat spots in the rubber - Texas UV cooks rubber over three or four summers. When the seal starts looking like an old tire sidewall, it’s done.
- Higher cooling bill or a garage that feels like a sauna in August - A failed weather seal lets conditioned air escape and outside air pour in. In Dripping Springs, that’s not a comfort problem. It’s a money problem.
Replacement Cost & What’s Included
A Clopay weather seal replacement in Dripping Springs runs $110-$220 installed on most residential doors. What moves the number is the seal style: a standard T-style bulb seal on a single door sits at the low end, while a wide double-door or a door with an aluminum retainer that’s also rotted out will push toward the high end. The price includes the part, the labor to pull the old seal out of the retainer channel and slide in the new one, and a check of the retainer itself. If the retainer’s bent or corroded, we’ll show you that before we touch anything. We quote the whole job on the phone and hold that number at the driveway, same as we’ve done since 2004. Every weather seal replacement carries the same 90-Day Done Right Promise as a spring job, in writing, on the invoice.
DIY or Call Us?
A weather seal isn’t a high-tension part like a spring or a cable, so it’s not dangerous in the way those are. You can safely inspect the seal yourself: close the door, lie a flashlight on the floor inside the garage pointing out, and see where the light escapes. That tells you whether the door’s sealing evenly or just wearing on one end. Where people get into trouble is forcing an aftermarket seal into a Clopay retainer that doesn’t match, then fighting the door when it binds. Or pulling the old seal and discovering the retainer’s screws are rusted through the aluminum, which turns a ten-minute job into a door-off-the-track headache. If you’d rather not wrestle it, call us at (737) 353-5361. We’ll stop by, match the seal, and be done before dinner.
FAQs
How long does a Clopay weather seal last in Dripping Springs?
A bottom seal lasts three to five years here, depending on sun exposure and door use. On west-facing doors in Dripping Springs with full afternoon sun, we’ve seen them crack in under three. EPDM rubber seals generally outlast vinyl by a year or two in this climate. Call (737) 353-5361 and we’ll come look at yours and tell you if it’s actually time.
Can you repair a torn weather seal instead of replacing it?
Not in a way that lasts. Once the rubber splits or the bulb flattens, patching or gluing buys you weeks at best. The honest fix is a new seal cut to the width of your door and slid into the retainer. For most Clopay doors that’s a fast, clean swap.
How long does the replacement take?
Most weather seal swaps take twenty to thirty minutes, by the time we pull the old seal, clean out the retainer channel, and slide in the new one. If the retainer needs attention, it can run longer, and we’ll tell you that before we start.
Do you stock Clopay weather seals on the truck?
Yes. We carry the common Clopay T-style and U-channel profiles on the truck so we can handle most replacement jobs the same visit. If your door takes an unusual profile, we’ll order it and have it within a couple of days. Call (737) 353-5361 and we’ll tell you over the phone whether we have yours on hand.
Written by Otto Reinhardt, Owner, Otto’s Garage Door - Dripping Springs, TX at Otto’s Garage Door, serving Dripping Springs and nearby areas.






Before
After
Before
After
Before
After